Search results
2. Install the right SIM card. 3. Provide power to the modem . 4. Connect modem to the PC with the mini USB cable. 5. Obtain the SIM card information. 6. Run the GPRS Config software and configure the modem for use with the SIM card. Once that is done, the modem connects to the internet and the logger is online. Remove cable from PC to modem.
Figure 2 GP2 Logger/Controller in MD-GPRS-DLC enclosure with GPRS modem, cabling, aerial, SOL4 solar power regulator and LBAT4 battery. Wiring scheme: see also page 25.
Page 47: Phase Selector Setup. Intersection Equipment Installation Instructions 7 Phase Selector Setup Indicators This section describes the indicators and switches The phase selector has the following seven on the front panel of the phase selector. indicators. See Figure 7-1 and Table 7-1.
This manual shows how to operate the device smoothly and correctly. Make sure to read this manual carefully before using this product. Please note that specification and information are subject to changes without prior notice in this manual. Any change will be integrated in the latest release.
GPRS/3G Settings. Cellular access can be added to the Com’X by installing a modem under the cover. This table illustrates GPRS/3G settings: GPRS/3G Only. GPRS/3G and 2 Ethernet Switched Ports (1 IP Address for Both Ports) Cellular network options depend on the modem that is connected.
Connect the positive & negative wire, red & black ones, with 12V or 24V car power system, wait for 1 minute after connecting power to and move the backup battery switch to "on" position. (The switch is located next to the sim card slot inside the casing)
How to Activate Tasslock 3G GPS. After Install Tasslock 3G GPS Wiring, Please first Insert Nano SIM card and Turn on the Switch (Photo Below) Login Via IMEI. Your Password is Last 6 Digits of IMEI Number. GPS Switch.
