Yahoo Poland Wyszukiwanie w Internecie

Search results

1. contenthub.cisco.com › chapterCisco Content Hub - Resetting the Controller to Default Settings

   contenthub.cisco.com › chapter

   • Zapisane w pamięci cache

   You can return the controller to its original configuration by resetting the controller to factory-default settings. This section contains the following subsections: Resetting the Controller to Default Settings (GUI)

   • Resetting the Controller to Default Settings - Cisco

     Enter the wireless device password in the Password text box...

2. www.cisco.com › en › USResetting the Controller to Default Settings - Cisco

   www.cisco.com › en › US

   • Zapisane w pamięci cache

   Enter the wireless device password in the Password text box and press Enter. The default password is admin. Step 5 Choose Commands > Reset to Factory Default. Step 6 Click Reset. Step 7 When prompted, confirm the reset. Step 8 Reboot the controller without saving the configuration.

3. www.cisco.com › m_resetting_controller_to_default_settingsResetting the Controller to Default Settings - Cisco

   www.cisco.com › m_resetting_controller_to_default_settings

   Step 3. When you are prompted for a username, enter the recover-config command to restore the factory-default configuration. The controller reboots and displays this message: Welcome to the Cisco WLAN Solution Wizard Configuration Tool. Use the configuration wizard to enter configuration settings.

4. community.cisco.com › t5 › wirelessPlease how to reset password for AIR-CAP3702E-E-K9 - Cisco...

   community.cisco.com › t5 › wireless

   • Zapisane w pamięci cache

   27 wrz 2017 · Options. 09-27-201703:44 AM. Just confirming you are doing the following: Power off. Holding mode button, power AP on. Continue holding for ~20 seconds until LED turns solid red. Release mode button. Power cycle once more as normal and wait for boot. Login with Cisco/Cisco.

5. www.cisco.com › c › enCisco Wireless Controller Configuration Guide, Release 7.6

   www.cisco.com › c › en

   • Zapisane w pamięci cache

   11 lip 2014 · The default password is admin. Step 5: Choose Commands > Reset to Factory Default. Step 6: Click Reset. Step 7: When prompted, confirm the reset. Step 8: Reboot the controller without saving the configuration. Step 9: Use the configuration wizard to enter configuration settings.

6. community.cisco.com › t5 › wireless-mobility-knowledge-baseHow to reset a Wireless LAN Controller (WLC) to factory defaults

   community.cisco.com › t5 › wireless-mobility-knowledge-base

   • Zapisane w pamięci cache

   18 lis 2020 · Complete these steps to reset the WLC to factory default settings using the CLI: Enter reset system at the command prompt. At the prompt that asks whether you need to save changes to the configuration, enter Y or N. The unit reboots. When you are prompted for a username, enter recover-config to restore the factory default configuration.

7. community.cisco.com › t5 › networking-knowledge-basePassword recovery - Cisco Community

   community.cisco.com › t5 › networking-knowledge-base

   • Zapisane w pamięci cache

   This document describes the procedure for recovering an enable password or enable secret passwords. These passwords are used to protect access to privileged EXEC and configuration modes. The enable password password can be recovered but the enable secret password is encrypted and can only be replaced with a new password using the procedure below.