Search results
The following sequence of steps is by no means the only way to assemble the Renard SS24. It is simply a suggested order of events to achieve the desired goal. NOTE: The part numbers referenced in the following instructions are those taken from the Renard SS24 BOM.
Renard SS24 Basic Setup Steps. Ensure all power is OFF. Remove all cables. If installed, remove all 30 removable IC chips (U2, U4 thru U8, and M1 thru M24). Perform a complete and thorough inspection of the underside of the PCB. Check all the solder pads for clean solder joints, no bridging between adjacent pads and that all pads did get soldered.
Christmas Light Controller Time-lapse Assembly.
First completed and functioning 24 channel light controller tested using an 8 channel arch.
15 lis 2010 · Sorta,... video accelerated by 1000%First half recorded with Flip Mino HD and second half done with my Droid X. If you would like to see a particular sectio...
The document provides step-by-step assembly instructions for building the Renard SS24 light controller board. It lists 34 steps to install various components like resistors, capacitors, LEDs, heat sinks, and ICs onto the PCB board.
NOTE: The part numbers referenced in the following instructions are those taken from the Renard SS24 BOM. 1 - Start by checking the PCB over for any obvious production faults. Check for traces that end abruptly or have cracks/breaks in them. Also check that all holes are clear. 2 - Install four diodes D1 thru D4 (PN# 625-1N5817-E3).
