Search results
Guardrail systems. The employer must ensure guardrail systems meet the following requirements: 1910.29 (b) (1) The top edge height of top rails, or equivalent guardrail system members, are 42 inches (107 cm), plus or minus 3 inches (8 cm), above the walking-working surface.
Where workers on a construction site are exposed to vertical drops of 6 feet or more, OSHA requires that employers provide fall protection in one of three ways before work begins: Placing guardrails around the hazard area. Deploying safety nets.
Guardrail systems. Guardrail systems and their use shall comply with the following provisions: 1926.502 (b) (1) Top edge height of top rails, or equivalent guardrail system members, shall be 42 inches (1.1 m) plus or minus 3 inches (8 cm) above the walking/working level.
The employer must ensure guardrail systems meet the following requirements: (1) The top edge height of top rails, or equivalent guardrail system members, are 42 inches (107 cm), plus or minus 3 inches (8 cm), above the walking-working surface.
The employer must ensure: (i) Each employee less than 4 feet (1.2 m) above dangerous equipment is protected from falling into or onto the dangerous equipment by a guardrail system or a travel restraint system, unless the equipment is covered or guarded to eliminate the hazard.
Guardrail requirements are outlined in IBC Section 1013 (Guards) and Section 1607.8 (Loads on Handrails, Guards, Grab Bars, Seats and Vehicle Barriers). OSHA fall protection requirements for general industry and construction are addressed in 29 CFR
What Are OSHA’s Guardrail Requirements? Fall protection in general—and the use of railings and guardrail systems in particular—is covered under OSHA’s walking and working surfaces rule, 1910 Subpart D, which was updated in 2017.
