Search results
23 wrz 2021 · For Cisco Nexus 9332PQ devices, 1/27-32 ports form the only port speed group. Use the speed-group 10000 command to configure the first port of a port speed group for the QSA. This command specifies the administrator speed preference for the port group. (The default port speed is 40G.)
10 gru 2012 · Siêu phẩm NUXUS 10 THÔNG SỐ KỸ THUẬT Hệ Điều hành: Android 4.2 Chíp: 1.70GHz Samsung Exynos 5250 2GB RAM ROM 32GB CAMERA Trước 5 MP, sau 1.9 MP WiFi 802.11 b / g / n (MIMO + HT40) Màn hình10…
22 paź 2021 · For 7.0(3)I3(1) and later, the Cisco Nexus C9332PQ Switch provides 24 40G ports that support breakout mode and can be connected to four 10G NIF ports on a FEX. Ports 1 - 12 and 15 - 26 ports are supported.
First digit, 1/X/X, means it's either 1st Switch or Module/Blade. Last digit, X/X/1, means it's the first port.
When this problem occurs, the port stays in a transit port state and you see no signal. There is no synchronization at the MAC level. The problem might be related to the port speed setting or autonegotiation.
30 lis 2020 · HostZ is an ESXi. Here's the question: - The output from the lacp neighbor command shows that HostZ is not establishing lacp peering with neither NX5K_A nor NX5K_B; however, the output from the show vpc command shows that the vpc is up/up.
20 gru 2019 · There is a port channel to an access switch with two uplinks, one from core switch 1 and one from backup core switch. (Port 1/2/0/5 to ten1/1/1 and port 2/2/0/5 to ten 1/1/2). To check the backup on access switch I shutdown port 1/1/1 and now the connection is lost.
