Search results
I am working to route all network traffic on an instance of Ubuntu over a Cisco VPN at a university. Using either the built in network manager or vpnc, I can successfully establish a connection to the VPN, and can successfully route traffic to any university IP over the VPN.
- linux - Route specific ip adress through VPN gateway - Super User
You want to be using the route add commands, but it appears...
- linux - Route specific ip adress through VPN gateway - Super User
Try running this command if you want to add a static route for only a single host. nmcli connection modify <Connection-Name> ipv4.routes '10.20.30.40/32' Or this if you want to add a static route to a subnet. nmcli connection modify <Connection-Name> ipv4.routes '10.20.30.0/24'
1 sie 2019 · In a general approach you might add a static/default route for all internet bound traffic on the client router to be forwarded through the tunnel to your main router, which implies a Site-to-Site VPN tunnel.
17 maj 2011 · You have a local LAN (for example, say 10.0.0.0/16, and a remote Cisco VPN Server (for example, 64.0.0.0/16). You want to connect to the VPN server through the Cisco VPN client and yet you need to have the LAN access. In this case you want to separate the whole 10.0.x.x/16 from the VPN connection). The following route must be added in a Mac client:
19 lut 2019 · You want to be using the route add commands, but it appears you have the wrong IP for your VPN's gateway. First, the command you want to use is: route add -host <Remote Server IP> gw <Local IP of VPN Gateway>
The ip community-list command is used to filter BGP routes based on one or more community values. BGP community values are configured as a 32-bit number (old format) or as a 4-byte number (new format).
31 maj 2019 · On Linux you can adjust the routing rules using ip rule and ip route commands. The latter one is a more advanced equivalent for the route command.
