Search results
10 cze 2021 · I just found the perfect swag pendant light at a salvage yard, brought it home, plugged it in, and it works!!! However, the chain on the swag is very corroded and rusty and needs to be replaced. Any suggestions on a) how to get it off and b) how to put a new one on?
11 cze 2021 · Instructions for How to Re-Wire a Vintage Lamp. 1. Remove the Old Cord. 2. Remove All Parts of the Re-wiring kit From the Bag. 3. Thread the New Cord up Through the Base of the Lamp. 4. Spread the Cord Apart a Bit in the Middle. 5. Strip Back Some of the Cord Covering with a Wire Cutter. 6. Tie an Underwriter’s Knot in the Cord. 7.
30 wrz 2024 · Begin by carefully removing the lamp shade, setting it aside in a safe location. If your lamp features a harp—the metal frame that holds the shade—gently detach that as well. Next, focus on the socket. Depending on your lamp's design, you may need to unscrew or disconnect the socket from the base.
17 sie 2005 · How do I convert my swag lamp to be hardwired to existing electrical box in ceiling, so I can switch it on/off at existing switch? Right now it is wired with a typical plug-in swag kit.
14 lut 2020 · The basics are you need to install the new part with the correct polarity and you need to assure that any tugs on the lamp cord are resisted by a knot in the cord under the lamp base, NOT the...
Step 3: Knot and Secure the New Cord. I received some really fun fabric-covered lamp cord from Color Cord Company. I used a special razor tool to cut the taped fabric layer and wire insulation, then stripped the wire ends. Once the lamp cord is inserted through the lamp, it’s time to tie the two ends in a lineman’s knot.
1 lut 2021 · Thread your base cord through the bottom-most part of your tension pole lamp, where the original cord had been. The stripped wires should be going up through any lower piece that connects to your torched piece, and the plug should be stuck outside of the bottom piece.
