Search results
How to Install and Remove Molex Connectors: Adding connectors to wires helps with connectivity and allows for plug and play compatibility with electronic and electrical devices. This guide will provide an overview of adding and removing Molex connectors and housing to wires and the how-to pro….
18 mar 2021 · Follow the 3-part process below to connect wires to a Molex connector, as well as how to remove a wire from a connector without doing damage. Choose the right control system for your actuator and take a look through our range!
Use 2 x 10mm No 3 Staples and cut one side off each to make them 'L' shaped. Push one down each side of the pin you wish to remove.
25 mar 2004 · Removing the wires from a 3 pin connector is accomplished with a small straightedge screwdriver (think reading glasses repair kit small). Simply push in slightly the retention tab thru the small slot on the back of the connector, and pull the wire (s) out.
23 gru 2023 · Learn safe and effective methods for removing a Molex connector without causing damage. Follow these expert tips for successful disconnection.
Removing the Molex connector from the board so that the connector is not damaged and can be used again, by heating from the back of the board.
Remove a connector terminal pin that secures inside a connector housing with flared fins by using the Molex connector extraction tool. Unplug the connector and push the terminal pin into the female housing as far as it goes.
