Search results
Ham Radio HF/VHF Antenna Lengths Chart. Here is a handy chart for determing 1/4 wave verticals, 1/2 wave dipoles, and full wave loop lengths. All antenna lengths in the information below are in feet and are the results based on the standard formula of 468 / FMhz = total length in feet.
Matchbox performance will be determined by two factors: The length of the antenna wire, and the capability of the tuner. The length of the antenna wire should be between 24 and 60 feet for best performance. Additional counterpoise is not normally required, as the coax shield provides the counterpoise function.
2.1. Antenna length based on the following formulars: 1/2 λ dipole (feet)= 468 / frequency in Mhz. 1/2 λ dipole (meters) = 142.65 / frequency in Mhz. Full wave loop (feet) = 1005 / frequency in Mhz. Full wave loop (meters) = 306.32 / frequency in Mhz. Cut wire slightly longer for connecting insulators and pruning. 22-Jun-2007 09:30 AM.
1 wrz 2021 · This chart serves as an aid in trimming the length of HF antennas. The chart estimates, over the length of an approximate quarter wavelength, the required change in length to shift the fundamental antenna resonance by a specific amount of kHz.
In practice, to optimize NVIS (Near Vertical Incident Skywave) performance, deploy the antenna horizontally at a height of 1/8 wavelength on any given band for a 0–650 km (0–400 miles) coverage area. Where DX will occur into the greyline from 7.0-19MHz during evening or daytime deployments.
This article will focus mainly on the antenna we built at Alan Parks, N7SHA, QTH. But the techniques used are applicable to any antenna installation. However we will focus on the specific of an end fed wire which apply to all end fed wires regardless of length.
5 cze 2021 · Here is a simple antenna calculator for two popular forms of ham radio HF wire antennas: the horizontal dipole and the inverted "V". (Updated June 5, 2021) The Antenna Calculator for Half-Wave Dipoles
