Search results
General Pump 1174 Northland Drive • Mendota Heights, MN 55120 Phone: 651.686.2199 • Fax: 800.535.1745 www.generalpump.com • sales@gpcompanies.com Operating Instructions 1. Connect inlet filter to FSC gun inlet. 2. Connect to Pressure Washer. 3. Turn water on and open valve. Open trigger gun for flow of water through nozzles. Nozzles
The Hammerhead is ready for operation. 4. Walk slowly behind the Hammerhead cleaning as you go. If striping occurs, slow down your pace. 5. Periodically check weep hole on bottom of swivel. Water will seep slowly; if water shoots out, stop and replace seals. Swivel assembly can be rebuilt. 6. For maximum effectiveness keep spray tips clean. If ...
GENERAL PUMP A member of the Interpump Group DFSCP12E Flat Surface Cleaner 1. Connect directly to gun, lance or telescoping wand. 2. Turn water on and open trigger gun for flow of water through nozzles. Nozzles must have flowing spray. If not, remove tips and clean; reassemble, making sure nozzle groove is parallel to spray bar. Use thread
If the flat surface cleaner rotating arm is not spinning, tilt the flat surface cleaner up so you can see the underside of the deck. If a nozzle is not spraying it is plugged and needs to be cleaned.
PROFESSIONAL FLAT SURFACE CLEANER 8 DFSCP12 OPERATOR’S MANUAL GeneralPumpisa memberof theInterpumpGroup WARNING:ReadBeforeOperatingMachine Alwayswearprotectiveeyewear ... FROM GENERAL PUMP • full 12” Cleaning path • can be connected directly to a gun, lance or telescoping wand • lightweight, ANODIZED ALUMINUM COMPONENTS • durable ...
Grease the swivel with one or two grease gun pumps every 200 hours (or once about every 30 days of use). NOTE: After 50 hours of use, remove the inlet filter, take apart and clean
If the flat surface cleaner rotating arm is not spin-ning, tilt the flat surface cleaner up so you can see the underside of the deck. If a nozzle is not spraying it is plugged and needs to be cleaned. The best way is to do this is to remove the nozzle (9/16" wrench) and tap it on a hard surface (be careful not to damage the threads). Sometimes
