Search results
General Pump 1174 Northland Drive • Mendota Heights, MN 55120 Phone: 651.686.2199 • Fax: 800.535.1745 www.generalpump.com • sales@gpcompanies.com Operating Instructions 1. Connect inlet filter to FSC gun inlet. 2. Connect to Pressure Washer. 3. Turn water on and open valve. Open trigger gun for flow of water through nozzles. Nozzles
tips and clean; reassemble, making sure that groove of nozzle is parallel to spray bar. Use thread sealant when installing nozzles. 3. Start Pressure Washer. The Hammerhead is ready for operation. 4. Walk slowly behind the Hammerhead cleaning as you go. If striping occurs, slow down your pace. 5. Periodically check weep hole on bottom of swivel ...
Operating Instructions. Bolt four the washers. two halves of the handle together with the two M6 x 60mm long bolts, nylok nuts and. Connect the handle to the brackets on the deck with the two 55mm long pins and rings. Using thread sealant on hose’s male threads, connect the hose to the swivel on the deck.
Instructions. Connect to Pressure Washer. must Turn have water flowing on and spray. open valve. If not, Open remove trigger nozzle is parallel to spray bar. Use thread sealant when installing nozzles. tips and gun clean; for flow reassemble, of water through making nozzles. sure that Nozzles groove of. Start Pressure Washer.
Operating Instructions. ter, D40014, to FSC gun inl. Connect to Pressure Washer. flow of water through nozzles. Nozzles must have flowing spray. If not, remove tips and clean; reassemble, making sure that groove of . ozzle is parallel to spray bar. Use thread. alant when installing .
Operating Instructions. Connect to Pressure Washer. Turn through water nozzles. on and Nozzles open valve. must Open have flowing trigger gun spray. of water remove parallel clean; spray reassemble, bar. Use thread making sealant sure when that groove installing of nozzle nozzles. is. Start Pressure Washer. The Hammerhead is ready for operation.
If the flat surface cleaner rotating arm is not spin-ning, tilt the flat surface cleaner up so you can see the underside of the deck. If a nozzle is not spraying it is plugged and needs to be cleaned. The best way is to do this is to remove the nozzle (9/16" wrench) and tap it on a hard surface (be careful not to damage the threads). Sometimes
