Search results
20 sty 2019 · If you're happy with the 2wire as your firewall/router but want to use the Linksys as an additional access point (providing wireless signal in another area, perhaps), the setup is actually much simpler. Connect to the Linksys admin interface; Give it an internal IP that won't conflict with the 2wire (e.g. .254 instead of .1)
18 maj 2016 · If you're running your own router alongside the modem/router combo your ISP gave you, there's a good chance you're inadvertently giving yourself a huge headache and a host of difficult-to-pin-down network problems. Let's look at why these issues arise, how to detect them, and how to fix them.
Make sure your 2Wire or Pace gateway and computer are connected by an Ethernet cable, and the connection is secure on both ends. Log in to your gateway on the connected computer.
21 lut 2021 · Set your router's WAN interface to get an IP address via DHCP. This is required at first so that the 2Wire recognizes your router. Plug your router's WAN interface to one of the 2Wire's LAN interfaces. Restart your router, let it get an IP address via DHCP. Log into the 2Wire router's interface.
RG = routing gateway. You can think of this as the most "upstream" router. Usually it's the modem/router combo provided by AT&T. ONT = optical network terminal. The device that converts the signal from light sent over fiber to electrical signal used in ethernet.
The 2-wire is a router/modem combo, yes? And it has the local ip 192.168.0.1? Both the router and modem part of this 2-Wire device share the same local ip address, is that right? The 192.168.0.254 address is for the household router.
7 gru 2022 · The passthrough mode for 2Wire/gateways in referred to as DMZplus mode. The device that you would like to be placed in DMZplus must be connected directly to the gateway and configured to obtain an IP address through DHCP.
