Search results
Pre-set Using the Fitting Body or Hardened Pre-assembly Tool. Pre-setting with the fitting body is only recommended for steel and copper tubes. For frequent pre-setting, stainless steel tube and hose standpipe fittings, a hardened pre-assembly tool (VOMO) is strongly recommended (see Fig. T40).
used in the manufacture of Industrial Pipe and Adapter fittings are shown in Table G2. Note: Upon request, pipe fittings, adapters and plugs could be furnished in materials other than those shown in the materials specifications chart. Finish - Zinc with Yellow Chromate is used on all standard steel products. Stainless steel fittings are passivated.
6 wrz 2020 · What is G1/4″? Regarding the fittings, there is one more detail you need to know. Almost all of the fittings nowadays use the G1/4“ thread (12.9mm wide) and this is the industry standard for all mainstream custom loop liquid cooling manufacturers.
To get an accurate value, ensure that the thread pitch gauge is fitting well on the threads. Record the values and compare your measurements with the figures provided in this guide. Accurate measurement of four-bolt flanges. Begin by using a caliper to measure the port hole diameter the bolt.
Subtract approx. 1/4″ (6mm) from thread diameter measurement for nominal pipe size. Pitch is Threads Per Inch (TPI). “Gas”, “R” & “G” also refer to BSP.
G-Series pipe thread chart (British standard pipe parallel was BSPP & BSPF) and PF-Series pipe thread chart (Japanese pipe parallel).
Standard Material Specifications: The standard materials used in the manufacture of Industrial Pipe and Adapter fittings are shown in Table G2. Note: Upon request, pipe fittings, adapters and plugs could be furnished in materials other than those shown in the material specifications chart.
