Search results
4 wrz 2020 · IMPORTANT: Before removing manual release valve, relieve pressure by fully extending cylinder. Screw the manual release valve in. Remove the retaining ring using a small pick or screwdriver. Discard the retaining ring.
4 wrz 2020 · Install connector on trim/tilt cable and reconnect trim connectors to engine wire harness. Release the tilt support and lower the outboard. Tighten the manual release valve to a torque of 45 to 55 in. lbs. (5 to 6 N·m).
Raise the outboard and engage the tilt support. Remove the rubber grommet from the blue/green trim/tilt cable connector. Remove the terminals from the connector by using a suitable tool to depress the tab. While the tab is depressed, pull on the wire from the rear of the connector to release it from the connector.
View and Download BRP Evinrude E-TEC G2 service manual online. Evinrude E-TEC G2 outboard motor pdf manual download. Also for: E 250 l ho ag b.
View and Download Evinrude E-Tec 40 HP service manual online. E-Tec 40 HP engine pdf manual download. Also for: E-tec 65 hp, E-tec 90 hp, E-tec 50 hp, E-tec 60 hp, E-tec 75 hp.
Johnson_Evinrude 1990-2001 service manual.pdf - Free ebook download as PDF File (.pdf), Text File (.txt) or read book online for free.
• Shock absorption system must always be ready to absorb some blows to the lower parts of the outboard. • Outboard must not trim in too far suddenly. What can happen? Without shock protection, a blow like this could cause serious damage to the outboard and injury to boat occupants from the outboard or its parts entering the boat.
