Search results
In this video I am installing the turbo feed and drain lines as well as the waste gate block off plate
In this video we Install the oil drain line from the turbo, put in the new 240cc injectors (from a d16y8 Civic Si or EX), and cut/ install intercooler piping, couplers, and clamps.
15 lip 2009 · i was wanting some tips on good ways to run the oil lines for my turbo kit because i dont have any yet...i have seen them 2 ways one way by taking out the...
The Garrett T-28 ball bearing turbo comes pre-assembled as one unit with a Ni-resist cast exhaust manifold and exhaust elbow, and inlet oil and water lines for the simplest possible installation.
18 gru 2009 · I have a decent collection of diagrams and schematics that I have either made or found and thought the folks might like them all in one place. Here they are. If you have any more, post them here and the mods can merge them. AEM/Perrin EBCS install diagram for externally gated turbos.
2 kwi 2020 · hi just bought the 2019 civic si and wanted to see if anyone knew of diagrams or manual that labeled all turbo piping, sensors, hoses so I can start working on it. I'm used to rebuilding old v8motors, so this is a whole different set up.
Once this is done, install the braided oil feed line onto the tapered –3 fitting. The line needs to be routed around the distributor side of the engine and pass under the distributor on its way to the turbo, where it should be fastened to the 90 degree –3 fitting installed on the top of the turbocharger bearing housing (see figure. 8).
