Search results
flight test evaluation of compliance with the requirements for circuit protective devices. It is made in response to recommendations from the National Transportation Safety Board.
(1) For levels 1 and 2 low-speed airplanes that do not meet single-engine crashworthiness requirements, a climb gradient of 1.5 percent at a pressure altitude of 5,000 feet (1,524 meters) in the cruise configuration(s);
2 mar 2016 · It requires to use oxygen when flying above 12500ft (3800m) for more than 30 minutes, and in any condition about 14000ft (4300m). The CS-23 certification requirements, which applies to aircraft 12500lb (5760kg) state the following for pressurization systems:
Certification in the normal category applies to aeroplanes with a passenger seating configuration of 19 or less and a maximum certified take-off mass of 8 618 kg (19 000 pounds) or less. Aeroplane certification levels are: Level 1 — for aeroplanes with a maximum seating configuration of 0 to 1 passengers;
23 mar 2016 · Level 1 Certification allows flyers to fly High Power Rockets with a total installed impulse up to 640 newton-seconds. Once you've read through this page, visit Launch Day for critical information on what to bring, wear, etc.
The Federal Aviation Regulations require that the minimum flight crew be provided with and use supplemental oxygen after 30 minutes of exposure to cabin pressure altitudes between 12,500 and 14,000 feet, and immediately on exposure to cabin pressure altitudes above 14,000.
10 kwi 2017 · However, when operating in direct conjunction with the type or supplemental type certification of the aircraft, that person shall operate under the experimental aircraft limitations of § 21.191 of this chapter and when flight testing, shall operate under the requirements of § 91.305 of this part.
