Search results
Convert slopes pitch between degrees, gradients and grades. Slope or gradient of a line describes the direction and the steepness of a line. Slope can be expressed in angles, gradients or grades.
- Chezys Conduit Flow Equation
The Chezys equation can be used to mean flow velocity in...
- Cylindrical Tanks or Pipes
Tank volume per foot depth. Septic Systems Septic systems...
- Excavation Slope
Excavation in sharp sand should be sloped 1 1/2 unit for...
- Roof Framing
In the United States, slope is typically given in inches per...
- Percentage
Percentage - Slope - Degree, Gradient and Grade Calculator -...
- Horizontal Storm Drain Piping
The table is based on a rainfall intensity of 100 mm per...
- Vehicles Traffic Flow and Density
k = n 5280 / l (2) where . k = vehicle density (vehicles per...
- Minutes Vs. Degrees
Minutes Vs. Degrees - Slope - Degree, Gradient and Grade...
- Chezys Conduit Flow Equation
2 dni temu · Elevation grade calculator determines the grade or slope of a specific earthen area, given its "rise" and "run".
Walkways should be designed so that they are sloped enough to keep water from puddling, but not so steep to be difficult for some populations to use. 0.5% minimum grading for drainage is suggested, but 1.5% is preferred.
The angle of a slope can be calculated using the online Slope calculator. Examples of the angle of a slope include such things as the angle of the driveway, the pitch of a roof, the angle of a hill and so on.
4 dni temu · To find the slope percentage, follow these steps: Measure the rise (the vertical distance that the terrain rises or falls). Make this number negative if we're going downhill. Measure the run (the horizontal distance covered by the slope). Divide the rise by run. Multiply the result by 100 to turn it into a percentage.
Assume the length between the stakes is 6 feet and you want a 2% grade. 1/4" x 6 = 1.5 inches. This means you want to toe to be 1.5 inches below the hinge. The difference between the desired grade (1.5") and the current grade (0.5") is how much you must cut from the toe stake.
Tool/Calculator to find a slope/grade value (of a road, a roof, a construction, a frame, etc.) from its height or width or length or distance etc.
